220V Dental Lamination Machine Dental Vacuum Forming Machine Dental Equipment With High Quality 1PC

220V Dental Lamination Machine Dental Vacuum Forming Machine Dental

Equipment With High Quality 1PC

Product parameter:

Power supply voltage: 220 v / 50 hz
Power: 1000 w
Installation dimensions: 25 * 21 * 30 cm
The weight: 6 kg

More parameters can be found in the English manual

Main functions:

1. The decolorizing braces molding and production;
2. Orthodontic maintain equipment, dental arch splint molding and production
3. The periodontal disease, fluoride treatment tray molding and production;

Instructions:

1, pull the lever up first, then after finishing the plaster cast on vacuum online.
2, put the film in interlining, tighten the screw fixed button.
3, open the heating switch observe the softness in the film to film heat evenly.
4, will tie down after the heating of soft film to cover on the plaster model,
5, close the heating switch, open the vacuum switch, vacuum 10 to 15 seconds, braces can be formed.
6, first pen on basis of gingival margin mark outside the film.
7, after the film cooling with scissors or grinding according to remove excess film, tag complete dentures.

Picture showing:

The evaluation details:

    Orthodontic transparent keep instruments have snap ring, beautiful, wear with comfort, maintain stable effect, and the advantages of simple was welcomed by the masses of oral surgeons,
I'm here to talk about it, and we are learning together.First to use different tools: plastic vacuum forming machine and special.Plastic sheet used in orthodontic hard, can choose 0.8 mm ~ 1.5 mm.

1 take impression.


2 pouring gypsum, gypsum model dry after dressing, should remove jaw and tongue, it's better to form "U" type.


3 in molding machine placed on molding, clamping, carry to heating.The best model will be on vacuum machine molding machine vacuum suction cups.


4 use vacuum heater for heating plate, let the sag of 2 cm.The deeper the sag, the thinner retainer.It will move on the model, until fully into the place.


5 use vacuum suction 15-20 seconds to make sure that the molding.The heater, after waiting for mould piece cool it off.


6 will spare trim off with scissors, or vehicles under the needle is directly along the transparent 2 ~ 3 mm under the ground, edge trimming, retains the gingival margin of 0.5 mm..


7 braces after pruning, braces on model again, check whether the match.An orthodontic made the retainer is like this, if you feel the edge is not closed, you can use alcohol lamp baking, bend inward, until closed.
The same method, choose different thickness and hardness of plastic, can be used to make whitening plates, night grinding pad, etc.

Note:Other type of this kind machine for optional